12 · Receiver Operation

Receiver Operation

Read your tally state on the camera-mounted receiver, change the camera number with the button, and manage the battery.

Ready-made kit (master & receivers)

Before you start

Reading the screen#

Short presses cycle three pages.

Display	How to read
Tally page	Current PGM (on air) and PVW (next) camera numbers
LED color	Red = PGM, green = PVW, off/blue = OFF
System Info	Camera ID, version, and other basics
RX Stats	RSSI, packet rate, and error counts

Outdoor tip

Red LEDs can wash out in sunlight — watch the OLED Tally page too.

Action	Function
Short press (~0.5s)	Cycle OLED pages
Long press (~2s)	Enter camera-number change mode
Release in change mode	Save the displayed number

1
Long press
Hold about 2 seconds while on → CAMERA ID popup appears on the OLED
2
Cycle
Numbers cycle 1 → 2 → … → 20 → 1 every 0.8s → wait for the one you want
3
Release
Let go → that number is saved automatically and reaches the master list within ~30s

Buttons are blocked in STOPPED

With the STOPPED overlay (invalid license), button input is blocked — follow the recovery in 07 · License.

Assigning from the master web side: 11 · Managing Receivers.

Exact charge is visible on the master web UI Devices page (not on the receiver OLED).
On low charge the LED dims in steps, then a 10-second countdown precedes deep sleep.
Charge over USB-C (amber LED while charging) — usable while charging, about 2-3 hours to full.

Next steps

Last modified —